RIGGING INSPECTOR TRAINING
Rigging inspector Training Program was developed specifically for those personnel responsible of inspection criteria to rigging hardware used on mobile cranes operations. It includes detailed information required to successfully complete the written testing requirements for Rigging Inspector Certification. All personnel involved in Crane Operations will all benefit greatly from this training course.
TRAINING CONTENT
- Applicable Regulations and Standards
- Rigging Basics
- Rigging Hardware, Accessories
- Auxiliary Rigging Equipment
- Sling Terminology & Types of slings
- Selecting the Right Sling
- Basic Sling Configurations
- Basic Sling Attachments & Configurations
- Basic Load Rigging Procedures
- Calculating Sling Stresses
- Load Angle Factors
- Rated Capacity
- Rigging Considerations
- How to Determine Load Weight
- Determining Gravity Center of Loads
- Load Balancing
- Travel Path, Guidelines for Load Handling and Taglines
- Hand Signals
- Training Techniques
- Using Sling Capacity (Load) Charts
- Using Shackles and Hooks Properly
- Wedge Sockets
- Overview of Wire Rope and End Fittings
- How to Properly Perform a Pre-Use Sling Inspection
- How to Apply Current Reg. and Std to Your Operation
- Riggers Checklist
- Rigging Safety
- Working Around Power Lines
- Evaluation (Rigger Verification of Knowledge and Skills)
Immediately following the completion of this training program, a block of time has been reserved for administration of written testing certification. A Certificate of Competency is issued to those who successfully complete all requirements set forth SOTOSAFETY CRANE & LIFTING Inc.